diff --git a/marlinfw-skr-e3-mini-v2/config-2.0.9.3/Configuration.h b/marlinfw-skr-e3-mini-v2/config-2.0.9.3/Configuration.h index 44c9f11..96a82a9 100644 --- a/marlinfw-skr-e3-mini-v2/config-2.0.9.3/Configuration.h +++ b/marlinfw-skr-e3-mini-v2/config-2.0.9.3/Configuration.h @@ -1033,7 +1033,7 @@ * The probe replaces the Z-MIN endstop and is used for Z homing. * (Automatically enables USE_PROBE_FOR_Z_HOMING.) */ -#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN +//#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN // Force the use of the probe for Z-axis homing //#define USE_PROBE_FOR_Z_HOMING @@ -1067,7 +1067,7 @@ * Use G29 repeatedly, adjusting the Z height at each point with movement commands * or (with LCD_BED_LEVELING) the LCD controller. */ -//#define PROBE_MANUALLY +#define PROBE_MANUALLY /** * A Fix-Mounted Probe either doesn't deploy or needs manual deployment. @@ -1182,7 +1182,8 @@ * | [-] | * O-- FRONT --+ */ -#define NOZZLE_TO_PROBE_OFFSET { 10, 10, 0 } +//#define NOZZLE_TO_PROBE_OFFSET { 10, 10, 0 } Only of interest with BLTouch +#define NOZZLE_TO_PROBE_OFFSET { 0, 0, 0 } // Most probes should stay away from the edges of the bed, but // with NOZZLE_AS_PROBE this can be negative for a wider probing area. @@ -1557,7 +1558,7 @@ * these options to restore the prior leveling state or to always enable * leveling immediately after G28. */ -//#define RESTORE_LEVELING_AFTER_G28 +#define RESTORE_LEVELING_AFTER_G28 //#define ENABLE_LEVELING_AFTER_G28 /** @@ -1667,8 +1668,8 @@ //=================================== Mesh ================================== //=========================================================================== - #define MESH_INSET 10 // Set Mesh bounds as an inset region of the bed - #define GRID_MAX_POINTS_X 3 // Don't use more than 7 points per axis, implementation limited. + #define MESH_INSET 35 // Set Mesh bounds as an inset region of the bed + #define GRID_MAX_POINTS_X 4 // Don't use more than 7 points per axis, implementation limited. #define GRID_MAX_POINTS_Y GRID_MAX_POINTS_X //#define MESH_G28_REST_ORIGIN // After homing all axes ('G28' or 'G28 XYZ') rest Z at Z_MIN_POS