1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
|
diff --git a/marlinfw-skr-e3-mini-v2/config-2.0.9.3/Configuration.h b/marlinfw-skr-e3-mini-v2/config-2.0.9.3/Configuration.h
index 96a82a9..44c9f11 100644
--- a/marlinfw-skr-e3-mini-v2/config-2.0.9.3/Configuration.h
+++ b/marlinfw-skr-e3-mini-v2/config-2.0.9.3/Configuration.h
@@ -1033,7 +1033,7 @@
* The probe replaces the Z-MIN endstop and is used for Z homing.
* (Automatically enables USE_PROBE_FOR_Z_HOMING.)
*/
-//#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN
+#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN
// Force the use of the probe for Z-axis homing
//#define USE_PROBE_FOR_Z_HOMING
@@ -1067,7 +1067,7 @@
* Use G29 repeatedly, adjusting the Z height at each point with movement commands
* or (with LCD_BED_LEVELING) the LCD controller.
*/
-#define PROBE_MANUALLY
+//#define PROBE_MANUALLY
/**
* A Fix-Mounted Probe either doesn't deploy or needs manual deployment.
@@ -1182,8 +1182,7 @@
* | [-] |
* O-- FRONT --+
*/
-//#define NOZZLE_TO_PROBE_OFFSET { 10, 10, 0 } Only of interest with BLTouch
-#define NOZZLE_TO_PROBE_OFFSET { 0, 0, 0 }
+#define NOZZLE_TO_PROBE_OFFSET { 10, 10, 0 }
// Most probes should stay away from the edges of the bed, but
// with NOZZLE_AS_PROBE this can be negative for a wider probing area.
@@ -1558,7 +1557,7 @@
* these options to restore the prior leveling state or to always enable
* leveling immediately after G28.
*/
-#define RESTORE_LEVELING_AFTER_G28
+//#define RESTORE_LEVELING_AFTER_G28
//#define ENABLE_LEVELING_AFTER_G28
/**
@@ -1668,8 +1667,8 @@
//=================================== Mesh ==================================
//===========================================================================
- #define MESH_INSET 35 // Set Mesh bounds as an inset region of the bed
- #define GRID_MAX_POINTS_X 4 // Don't use more than 7 points per axis, implementation limited.
+ #define MESH_INSET 10 // Set Mesh bounds as an inset region of the bed
+ #define GRID_MAX_POINTS_X 3 // Don't use more than 7 points per axis, implementation limited.
#define GRID_MAX_POINTS_Y GRID_MAX_POINTS_X
//#define MESH_G28_REST_ORIGIN // After homing all axes ('G28' or 'G28 XYZ') rest Z at Z_MIN_POS
|
